Why does my electric gate not work?

There are many reasons electric gates do not work, including dead batteries, cold weather, damaged photocells, dead remote batteries, power outages, being stuck in manual mode, signal interference or something physically blocking the gate.

How do you set the limit on a Centurion garage motor?

The limits must be started from approximately the midway position. Should the door be within approximately 200mm of the closed position, use the “+” button by pressing and holding it down to drive the door to the midway position then start the limit setup.

How do I pair my remote to my ET gate motor?

Press and hold the required remote transmitter button RX LED flickers lightly. Short circuit the middle RX programming pin to the BT pin. (Closest to the gate) RX LED flashes Confirmation. 1 flash = First transmitter learnt.

How to contact Centurion Systems (Pty Ltd)?

Centurion Systems (Pty) Ltd Tel +27(0)11 699 2400 Fax +27(0)11 704 3412 Unit 13 Northlands Production Park Intersection Epsom Avenue and New Market Street Northriding JOHANNESBURG 2196 PO Box 506 Cramerview 2060 South Africa [email protected] [email protected] GARAGE DOOR OPERATORS

Can I install the Xtrac on my garage door?

 The XTrac must only be installed on a properly balanced well functioning garage door. An improperly balanced or malfunctioning garage door could cause serious personal injury, death and / or property damage. Have a qualified person check and if required, make repairs to your garage door before installing the XTrac.

How does the Xtrac work?

 By intelligently reducing the speed of garage door as it approaches a limit point, the XTrac ensures quieter garage door closing and enhanced XTrac and garage door life. (Standard function within Adaptive Mode only)  Adaptive Mode is factory configured to provide soft stopping prior reaching a limit point.

Where can The Xtrac wall switch be mounted?

 The wireless wall switch provided with the XTrac kit vides ease of installation without the need for running hard wires to the switch. It can be mounted in a convenient location such as adjacent to a side entry door into the garage.