Where is the cruise control switch located?

Operating Cruise Control. Locate your car’s cruise control switches. Usually, these are found either on the steering column (the part connecting the steering wheel to the dashboard area), or on the steering wheel itself. Controls found on the steering wheel usually consist of a few buttons.

How do you test a Ford cruise control switch?

Hold the OFF button on the cruise. Without starting the engine and while keeping the off button held – quickly cycle the ignition key from RUN to OFF to RUN. 2. If done properly the cruise control indicator light will flash once to indicate that you have successfully entered the test mode.

Why was the Ford Explorer Sport Trac discontinued?

The Sport Trac was discontinued in 2010 when high fuel prices and the recession saw demand drop off considerably. Had Ford continued to develop the Explorer Sport Trac, it probably wouldn’t have needed to revive the Ranger.

How do I reset my cruise control?

The cruise control system will be reset to the speed you are travelling when you release the knob. For a quick reset, accelerate with the accelerator pedal to the desired speed, then press and release the “SET/COAST” button.

What causes the cruise control to stop working?

The most common reason a cruise control stops working is due to a blown fuse or a defective brake pedal switch. It can also be caused by issues with the throttle control system or the ABS. In older cruise control systems it can be caused by a broken vacuum line.

Why would cruise control stopped working?

A vehicle’s cruise control may stop working if the vacuum actuator has stopped working or if there is damage to the vacuum hoses. The system may also fail if the cable linking the actuator to the throttle is broken.

How long is a Sport Trac bed?

50-inch long
Designed specifically for the Sport Trac, the 50-inch long pickup bed was constructed entirely of plastic composite material; the tailgate was shared with the Ford F-150 SuperCrew.

What causes a cruise control to stop working?