You’ll find a white PVC or copper pipe located near your outdoor unit—this is where the drain line ends. Near your indoor unit, you’ll find a vertical PVC pipe with a cap on it, which acts as the access point for the condensate drain.

Where do I drain my HVAC condensate?

You’ll find a white PVC or copper pipe located near your outdoor unit—this is where the drain line ends. Near your indoor unit, you’ll find a vertical PVC pipe with a cap on it, which acts as the access point for the condensate drain.

What is a condensate trap HVAC?

The idea of the condensate drain trap is to use the weight of the water to stop the flow of air produced by the blower from being sucked into (negative pressure) into the evaporator coil or from being pushed (positive pressure) out of the drain line during operation.

How do you capture AC condensate?

No filtering or settling is necessary when using AC condensation for plants. One of the simplest ways to harvest the water is to collect it in a bucket outside the home. If you want to get fancy, you can extend the drip line directly into nearby plants or pots. The average home will produce 1 to 3 gallons (4-11 L.)

Where does condensate drain to?

In newer homes, HVAC condensate drains are tied most often to bathroom drains. Common drain lines inside your home include in your bathrooms (sinks, shower or tub, toilet), kitchen (sink, water line to your freezer), laundry room, and water heater.

What type of pipe is used for condensate?

The recommended material to use for a condensate system is stainless steel. Stainless steel greatly enhances the pipes’ ability to withstand the corrosive attack for a longer, more reliable operational life.

Should condensate trap be full of water?

The boiler should never be operated without the condensate trap in place, as it prevents noxious combustion gases from travelling down the condensate pipe. Should the trap have to be removed from the boiler, it must be topped up with water when it’s replaced.

Can you reuse condensate water?

Condensate reuse may include subsurface irrigation or process makeup (such as a cooling tower), where water is treated for biological contamination. If it is to be used for potable water or for washing, proper disinfection of the water is required.

How much condensate does an air conditioner produce?

5 to 20 gallons
Your air conditioner should naturally drain water that was once humidity out of your home. On average, you can expect 5 to 20 gallons of condensate per day.

Why use P trap for condensate drain?

The primary purpose of the P-trap in a plumbing system is to form an isolation seal between that system and the sanitary sewer, thereby preventing sewer gases and other contaminants from entering the building. For this application, the operating conditions are such that the P-trap provides an effective seal.

How much water should come out of AC drain line?

Your air conditioner should naturally drain water that was once humidity out of your home. On average, you can expect 5 to 20 gallons of condensate per day. If water is not draining, your climate may be too dry or your system is not functioning properly.

What is HVAC condensate and how is it used?

The condensate from heating, ventilation and air-conditioning (HVAC) systems has been identified as potential source of clean water, which is typically removed and disposed of in a sanitary drain. The condensate can be beneficially used for water sustainability and building energy recovery.

What is the collection potential of condensate?

Condensate collection potential is dependent upon such factors as the size and operational load of the particular system, ambient temperature and humidity. A general rule of thumb is that .1 to .3 gallons of condensate is produced for every ton-hour. Collection Potential Page 14

What is HVAC condensate recovery?

The condensate can be beneficially used for water sustainability and building energy recovery. The focus of this article is a state of the art review of HVAC condensate recovery, the progress in research and development of condensate recovery systems (CRSs), quality concerns and potential applications.

How much condensate does your Houston a/C system produce per minute?

Under those combined conditions, sweat drenches people, and condensation nearly pours off A/C coils. On a hot, humid day, the amount of condensate produced from the Brockman Hall A/C system equals an astonishing 15 gallons per minute. In many Houston buildings, HVAC condensate is discarded, simply sent down the sewer.