To use the UT2 to program a decoder you must first put the UT2 in Programming Mode. To do this press and hold “RUN/STOP” and simultaneously press “PROG”. The Status LED will now turn a steady orange color indicating the UT2 is now in Programming Mode.

How do you program a Digitrax decoder?

To use the UT2 to program a decoder you must first put the UT2 in Programming Mode. To do this press and hold “RUN/STOP” and simultaneously press “PROG”. The Status LED will now turn a steady orange color indicating the UT2 is now in Programming Mode.

How does Digitrax work?

With Digitrax you can run many trains at the same time just like on the real railroad. You can operate lights and sounds on the trains and at fixed locations around the layout. You can set up detection and signaling so you’ll know where your trains are at all times with Digitrax Transponding technology.

How do you reset a Digitrax DCS 52?

Press the “c – / CV-WR (lower right of keypad)” key to set the OpSw to closed and reset DCS51/DCS50. 5. Press EXIT when finished.

What are DCC CV’s?

Configuration Variables or CVs are memory addresses within a decoder. They are the means for controlling the performance of a DCC decoder. The decoder’s software creates and maintains these addresses. They can be used in a couple of different ways.

Which is better Digitrax or NCE?

The NCE system is simpler and more user friendly………… If you want to get into things like signaling, the Digitrax system allows more advanced features.

Where is Digitrax located?

Panama City, FL
Company Description: Digitrax, Inc. is located in Panama City, FL, United States and is part of the Electrical Equipment Manufacturing Industry.

How do I reset my Digitrax decoder?

To reset all CV values to their factory default, program CV08 to a value of 008/x08 while the locomotive is on the programming track. To reset all CV values except for 28 step speed tables to their factory values set CV08 to a value of 009/x09. Earlier Digitrax decoders must be reset manually, CV by CV.

What is a booster in Digitrax?

A Booster is the device that provides the electrical power to the railroad. Most Digitrax command stations have a combined booster. The command station generates the DCC signal then sends it through a booster to the layout. A small model railroad may only have the command station and booster, while a large railroad will have numerous boosters.

How does Digitrax DCC work?

Most Digitrax command stations have a combined booster. The command station generates the DCC signal then sends it through a booster to the layout. A small model railroad may only have the command station and booster, while a large railroad will have numerous boosters.

Why should I buy Digitrax?

You can see all of your tickets in one place, even if they are closed. Digitrax gives a one year “No Worries” Warranty against manufacturing defects and accidental customer damage on all Digitrax command stations, boosters, throttles, decoders, power supplies and layout control devices. That’s it!

How do I use the Digitrax LT1 decoder tester?

At Digitrax, the white wire is always on the right side of the plug when the plug is viewed with the clip at the top.3. Connect the other end of the LocoNet Cable being tested to any powered Digitrax Booster’s LocoNet Port A or B. Be sure you have at least one Digitrax throttle plugged in The LT1 is a simple decoder tester.