Retrieving codes: Turn the ignition key until the digital odometer displays, repeat three times in succession and then back to “On” (On/Off, On/Off, On/Off, On). At the fourth “On” the odometer will be replaced with codes. If no codes are present then “Done” will appear.

How do I find the error code on my Jeep Grand Cherokee?

Retrieving codes: Turn the ignition key until the digital odometer displays, repeat three times in succession and then back to “On” (On/Off, On/Off, On/Off, On). At the fourth “On” the odometer will be replaced with codes. If no codes are present then “Done” will appear.

How do you reset the code on a Jeep Grand Cherokee?

How to Reset the Fault Code on a Jeep Cherokee

  1. Pull the release lever to open the hood from inside the vehicle.
  2. Open the hood and place the support rod into position to prop up the hood.
  3. Remove the nut connecting the negative battery terminal to the battery, using an open end wrench.
  4. Allow the computer to reset.

How do you reset the check engine light on a Jeep Grand Cherokee?

How to Turn Off a Jeep Grand Cherokee Check Engine Light

  1. Turn your ignition key to the “Acc” position to power your vehicle’s computer and electronics. Do not crank the engine.
  2. Connect the OBD-II code scanner to the diagnostic tool in your Jeep Grand Cherokee.
  3. Press the button on the scanner to check the system.

How do I reset the anti-theft on my Jeep Cherokee?

Wait for a chime to sound and press and release the “Lock” and “Unlock” buttons on your remote. Press and release the “Lock” button by itself and wait for the car’s chimes to sound again to indicate successful resetting. Remove the key from the ignition when you are done to finish the procedure.

How do you reset the check engine light on a 2007 Jeep Grand Cherokee?

How Do I Reset My Jeep Grand Cherokee? Without starting the vehicle, turn the ignition switch to the “ON” position. When the gas pedal clicks in 10 seconds, hold it for three seconds each time. Start the engine after you have turned off the ignition and waited 10 seconds.

How to clear codes from a Jeep Grand Cherokee?

– Turn the key to ON, OFF, ON, OFF, ON stop .. – When the light goes off, get ready to start counting the light flashings. – Once the Check Engine Light has turned off, it will pause in the off position for a second or two, and then start to flash, count the flashes. – would be FLASH …

How do you unlock Jeep Grand Cherokee?

Matt18. I hope this isn’t a dumb question.

  • bill_de. It is a programmable choice in uConnect settings.
  • Matt18. It is a programmable choice in uConnect settings.
  • Spinach. When I first got mine I didn’t realize just how many settings could be changed in the Uconnect menu.
  • JTS97Z28.
  • turbospartan.
  • JeepCares.
  • xJoshxx.
  • oneframe.
  • BubbaATL.

    • How to reset the fault code on a Jeep Cherokee?

    Open the driver’s door on the Jeep Grand Cherokee and locate the diagnostic link connector under the dashboard.

  • Plug the OBD II scanner into the connector and then turn the ignition key to the power accessory position.
  • Refer to the operation manual of the scanner.
  • Scroll to the “erase codes” option displayed on the on-screen menu.

    • How to tune up a Jeep Grand Cherokee?

    – 1997 Jeep Grand Cherokee Orvis 6 Cyl 4.0L – 1997 – 1998 Jeep Grand Cherokee Laredo 6 Cyl 4.0L – 1997 – 1998 Jeep Grand Cherokee Limited 6 Cyl 4.0L