Can a Ficm be repaired?
If your FICM fails anytime within five years, we will repair it again. In the rare occasion that it is not repairable, we will either replace the circuit board entirely or refund the cost of the repair, at our discretion.
Table of Contents
Can a Ficm be repaired?
If your FICM fails anytime within five years, we will repair it again. In the rare occasion that it is not repairable, we will either replace the circuit board entirely or refund the cost of the repair, at our discretion.
How much does a Ficm cost?
Compare with similar items
| This item Ford 6.0 Powerstroke FICM Pre-Programmed Fuel Injection Control Module 4C3Z-12B599-ABRM | GB Remanufacturing 921-124 Fuel Injection ECU | |
|---|---|---|
| Add to Cart | Add to Cart | |
| Customer Rating | 5.0 out of 5 stars (6) | 4.8 out of 5 stars (11) |
| Price | $69995 | $432.78$432.78 |
| Sold By | RD Parts | Amazon.com |
What causes Ficm failure?
While engine heat and vibration contributes to FICM failures, the number one cause (arguably) is a low battery voltage condition. As the FICM supply voltage drops the electrical current increases, damaging the FICM’s fragile circuitry.
How do I know if my Ficm is bad?
You should have a minimum of 45 volts to be within specification with the ignition key in the RUN position, cranking and engine running. Any voltage reading below 45 volts indicates a bad FICM and will need to be replaced. If you receive a 0 voltage reading while cranking you may have a bad FICM fuse and or relay.
What is a BulletProof Ficm?
The BulletProof FICM is an upgraded power supply which is now available in both a 4-phase or 6-phase version. The BulletProof FICM also comes with an all-billet aluminum housing for improved heat dissipation and an updated look.
How do I know if my Ficm is going bad?
How do I check my Ficm?
Take a multi-meter set on DC volts and connect the ground lead to battery negative, and with the key ON measure the voltage at the screw on your right—closest to the driver’s side fender. Do not let the probe short against the case! The voltage should be right at 48 volts. Anything between 47 and 49 is good.
What codes will a bad Ficm throw?
Trouble Codes Set | Failing FICM The most common trouble codes for a failing FICM power supply, are P0611 (FICM performance) accompanied with all eight Injector Circuit Low codes (P0261, P0264, P0267, P0270, P0273, P0276, P0279, P0282).
Where is the Ficm fuse?
This is located under the hood in the Relay Panel (located by the driver’s side hood hinge).
