BENTON HARBOR, Mich., Sept. 27, 2011 /PRNewswire/ — The newest top-load laundry line from Maytag, the Bravos XL™ series, offers consumers an industry-best* Cold Wash cycle.

When was Maytag Bravos XL washer made?

BENTON HARBOR, Mich., Sept. 27, 2011 /PRNewswire/ — The newest top-load laundry line from Maytag, the Bravos XL™ series, offers consumers an industry-best* Cold Wash cycle.

What is the capacity of a Maytag Bravos XL washer?

4.5 cu. ft.
At 4.5 cu. ft. of capacity, Bravos XL HE washers are capable of washing even your largest loads. These washers have the ability to clean 21 towels in a single load….Maytag MVWB725BW.

Performance
Electrical Requirements: 120V; 60Hz; 15A
Product Depth: 27 5/8″
Product Height: 42″
Product Width: 27 9/16″

Why does my Bravos XL washer keep stopping?

If the door lock is defective, the washer may stop mid cycle. The door lock can fail either mechanically or electrically. Inspect the door lock for damage. If the door lock is damaged or does not latch properly, replace it.

Why is my Maytag Bravos washer so loud?

Maytag washers may make loud noises when there is a defect in the tub bearing or motor coupling, a worn-out drive pulley, damaged clutch assembly, or a clogged drain pump. Additionally, washers often make a squealing or whining noise when they’ve been overloaded.

How much does a Maytag Bravo XL washing machine cost?

The Maytag Bravos XL series of Washers and Dryers are marketed on the notion of having both a Extra Large capacity and still clean clothing with “High Efficiency” detergent. Maytag prices them between $900 – $1,200.

Who makes Bravo XL washer?

Maytag Bravos XL
Maytag Bravos XL 4-cu ft High Efficiency Impeller Top-Load Washer (White)

Who makes the Bravo XL washing machine?

Why does my Maytag washer stay on wash cycle?

Common solutions for: Maytag Washer stops mid cycle If the door lock is defective, the washer may stop mid cycle. The door lock can fail either mechanically or electrically. Inspect the door lock for damage. If the door lock is damaged or does not latch properly, replace it.

Why does my Maytag washer stop on the spin cycle?

One of the most common reasons for a Maytag top load washer not spinning is an incorrect wash cycle or spin setting. GENTLE, HANDWASH, or DELICATE settings utilize slower spin speeds for more fragile fabrics. Some model washers also allow you to vary the spin speed, making it slower or more rapid, for different loads.

Are there any recalls on Maytag washers?

The U.S. Consumer Product Safety Commission has announced a recall of about 270,000 Maytag and Samsung front-loading washing machines because of a fire hazard.

Why does my Maytag washer make a loud noise when spinning?

If your Maytag washer is making loud noises during its spin cycle, the most likely cause is a worn-out tub bearing. If the tub bearing is not responsible, one of the suspension components or the spider support arm (front-load washers only) is likely responsible for the noise issue.